Journal of Agricultural Science and Technology ›› 2022, Vol. 24 ›› Issue (6): 106-114.DOI: 10.13304/j.nykjdb.2021.0483

• INTELLIGENT AGRICULTURE & AGRICULTURAL MACHINERY • Previous Articles    

Design and Experiment of Pneumatic Fertilizer Collecting and Discharging Device for Ratooning Rice

Huibin KE(), Yong ZHOU(), Guozhong ZHANG, Wen LYU, Yan LIU, Lin HUANG   

  1. Key Laboratory of Agricultural Equipment MARA Middle and Lower Reaches of the Yangtze River,Ministry of Agricalture and Rural Affairs; College of Engineering,Huazhong Agricultural University,Whuhan 430070,China
  • Received:2021-06-12 Accepted:2021-08-23 Online:2022-06-15 Published:2022-06-21
  • Contact: Yong ZHOU

再生稻气力式肥料集排装置的设计与试验

柯烩彬(), 周勇(), 张国忠, 吕文, 刘沿, 黄琳   

  1. 华中农业大学工学院,农业农村部长江中下游农业装备重点实验室,武汉 430070
  • 通讯作者: 周勇
  • 作者简介:柯烩彬 Email:khb@webmail.hzau.edu.cn
  • 基金资助:
    国家重点研发计划项目(2016YFD0300907)

Abstract:

To solve the problems of uneven fertilization and low utilization rate in traditional topdressing of ratooning rice, a pneumatic fertilizer collecting and discharging device was designed. In this study, the main factors affecting the fertilization performance were tested with the tool of quaternary quadratic regression orthogonal rotation combination, and a regression model was established using the uniformity variation coefficient of each row’s fertilizer discharging volume as the evaluation index to study the of influence angle of the fertilizer inlet, height of the fertilizer inlet, length of the bellows and the speed of the fertilizer discharging shaft on the uniformity of fertilizer discharging in each row. The results showed that the main factors affecting the device’s uniformity variation coefficient of the fertilizer discharging volume were ranked with the speed of the fertilizer discharging shaft, the angle of the fertilizer inlet, the length of the bellows, the height of the fertilizer inlet. Using Design-Expert10.0 software, the optimal combination of the parameters was obtaing the angle of the fertilizer inlet was 54°, the height of the fertilizer inlet was 216 mm, the length of the bellows was 200 mm, the speed of the fertilizer discharging shaft was 47 r·min-1. Under these conditions, the uniformity variation coefficient of the fertilizer discharging volume of each row is 1.71%, which could sufficiently meet the topdressing requirements of ratooning rice.

Key words: ratooning rice, pneumatic, top dressing, fertilizer collecting and discharging

摘要:

针对再生稻传统追肥作业中施肥量不均匀、肥料利用率低等问题,设计了一种气力式肥料集排装置。对影响施肥性能的主要因素进行四元二次回归正交旋转中心组合试验,以各行排肥量一致性变异系数作为评价指标建立回归模型,研究进肥角度、进肥高度、波纹管长度及排肥轴转速对各行排肥量一致性的影响。结果表明,影响此气力式肥料集排装置各行排肥量一致性变异系数的主要因素顺序为排肥轴转速>进肥角度>波纹管长度>进肥高度。采用Design-Expert10.0软件进行优化分析得出最佳的参数组合:进肥角度54°、进肥高度216 mm、波纹管长度200 mm、排肥轴转速47 r·min-1,此时各行排肥量一致性变异系数为1.71%,施肥均匀性较好,能够满足再生稻追肥要求。

关键词: 再生稻, 气力式, 追肥, 肥料集排

CLC Number: